Before
After
Boiler Replacement in Waterloo, NY
This Waterloo, NY customer’s 30+ year old boiler has been limping along for years. Instead of replacing parts and wondering if the boiler would make it through another winter, the customer decided to contact Halco for a replacement. We installed a new Williamson atmospheric vented water boiler and the customer will now have peace of mind knowing they will stay warm this winter!
Before
After
Furnace Replacement in Dryden, NY
This Dryden, NY customer had a 30-year-old gas furnace that was drastically over sized at 100,000 btu. We replaced the 80% efficiency, single stage furnace with a 96% efficiency, 60,000 btu, 2 stage furnace. At the same time, we added AC and did a duct cleaning for the customer!
Before
After
Pressure Tank Replacement in Clifton Springs, NY
This Clifton Springs customer was having intermittent issues with his water due to an old pressure tank with a bad relay switch. We removed the old tank and 4-feet of galvanized piping and installed a new v100 tank with pex piped in.
Before
After
Attic Insulation in Historical Fayetteville, NY Home!
This customer worked with Halco to convert his historical home in Fayetteville, NY into an energy efficient home. While the focus of this job was a complex geothermal system, Halco and the customer himself did a tremendous amount of work prior to installation.
We fully believe in the concept of “Reduce Before You Produce,” so the home was tightened as an initial step. We vacuumed out all the loose fiberglass and spray foamed the roof decks and gables, bringing the attic into the thermal boundary.
Before
After
Pressure Tank Replacement in Auburn, NY
This Auburn, NY customer’s pressure tank was waterlogged which made his well pump turn on every time he turned a faucet on. As this would eventually burn the pump out, we replaced the pressure tank and updated the piping.
Before
After
Boiler Replacement in Clifton Springs, NY
This Clifton Springs, NY customer contacted Halco for an estimate on replacing his very old steam boiler. After properly sizing a new system, we installed a natural gas steam boiler that included a prefabbed riser, header and hartford loop. An automatic water feed was also included in this installation.
Before
After
Navien Install in Ithaca, NY
After this Ithaca, NY customer had a couple radiators freeze and break over the winter, he contacted Halco for a no-cost heating estimate to replace the radiators and current system. We installed this Navien high efficiency boiler and moved the water heater to allow for room to install the Navien. We also removed the broken radiators and installed two new ones!
Before
After
Ductless Heating & Cooling in Seneca Falls, NY
Mitsubishi Electric brings unmatched energy efficiency, performance and control to home cooling and heating. This multi-zone system was installed for a customer in Seneca Falls, NY to control two zones within their home. With a Mitsubishi multi-zone system you can individually control up to eight zones in your home from one outdoor unit for ideal personalized comfort.
Before
After
Condensate Pump Replacement in Auburn, NY
Before
After
AC Maintenance in Seneca Falls, NY
This Seneca Falls, NY customer contacted Halco to perform maintenance on her AC system. She was selling her house and having the system serviced was one of the contingencies. During a maintenance call, we ensure the system is running safely and at peak efficiency.
Before
After
AC Repair in Victor, NY
This new Halco customer contacted us because the AC system at his Victor, NY rental unit was not working correctly, and he thought it may need to be charged. Upon arrival, our tech found the outdoor unit in need of a cleaning. He performed a tune-up on the system, added refrigerant, and changed the valve cores and caps. The AC was operational when complete.
Before
After
AC Repair in Lansing, NY
This was a new Halco customer that contacted us because her AC unit was not working properly and was blowing warm air. The customer’s home had gotten up to 84 degrees, and she was especially concerned because she had an infant in the home. The Halco tech cleaned the unit and performed a tune-up on the system. He also replaced the contactor. Upon completion, the unit started and ran properly.












